Garage entry points

Garage Door Gaps and Rodents: Bottom Seals, Side Seals and Threshold Fixes

A garage door is the largest moving opening on most houses, and its edges wear out. A flattened bottom seal or a chewed corner can leave a gap big enough for a mouse or a young rat.

Serving Mesquite 75149, 75150, 75180, 75181 and 75182

Garage door gap check

  • Mouse gapAbout ¼ inch
  • Rat gapAbout ½ inch
  • CheckBottom corners first
  • TestDaylight from inside
  • Common fixNew seal + side seals

How do I rodent-proof my garage door?

Close the door, turn off the garage lights and look for daylight along the bottom and both sides. Replace a cracked or flattened bottom seal, add brush or rubber side seals where the door meets the frame, and fix uneven slab edges with a threshold strip. Corners are where gaps usually start.

University extension research puts the gaps mice can squeeze through at about a quarter inch, and a young rat can get under a door with a half-inch gap. Garage doors often have both, especially at the corners where the door seal is bent, torn or chewed. The garage then becomes a staging area: rodents shelter among stored boxes and find their way into the house through the door to the kitchen or utility room.

Find the gaps

  1. Close the door fully on a sunny day.
  2. Turn off the lights inside and look along the bottom edge and both sides for light.
  3. Check the two bottom corners closely. Uneven slabs, worn seals and chewing all show up there first.
  4. Look at the seal itself: cracks, flat spots, missing sections or tooth marks.
  5. Slide a pencil under the door at several points. If it passes easily, so can a mouse.

Photograph what you find. If you call someone to fix it, photos help them bring the right parts.

Bottom seals

The rubber or vinyl strip along the bottom of the door is the part that wears out most. Heat, sun and the weight of the door flatten it over time. Replacement strips are sold by profile (the shape that slides into the door’s retainer), so take a piece or a photo to the store.

Rubber and vinyl alone can be chewed. Where rodents are already chewing the seal, some homeowners and contractors add a metal or brush-type barrier along the corners, or a seal designed with an embedded wire mesh. UC IPM’s house mouse guidance lists rubber and vinyl among materials that mice can gnaw through and suggests covering edges with metal if gnawing happens.

Side seals and the frame

Gaps along the vertical sides of the door are easy to miss. Most doors have a weatherstrip on the stop molding (the trim the door closes against). If that trim is warped or the strip is missing, add a new rubber or brush strip that meets the door when it’s closed.

Also look at the bottom of the door frame on each side. Wood trim near the slab often rots or gets chewed, leaving a small opening at ground level beside the door.

Uneven slabs and thresholds

If the slab dips in one spot, a new seal won’t reach it. A garage threshold strip glued to the slab under the door can close a gap that a seal alone can’t. Make sure the strip doesn’t trap water against the door.

For cracked or broken concrete at the door line, repair the concrete. Mice and rats don’t chew concrete easily, which is why UC IPM recommends sealing foundation openings with metal or concrete.

Don’t forget the other garage doors

  • The door from the garage into the house: add a sweep at the bottom. This is the last barrier between garage rodents and your kitchen.
  • Side or back doors to the yard: check sweeps and weatherstripping.
  • Pet doors and dryer or water heater vents in the garage wall.

For removing rodents already living in the garage, see rats in the garage. For the full house, our rodent proofing and exclusion guide covers the other common gaps.

More questions

Will a new garage door seal stop rats?

It stops them from slipping under the door if it closes the gap fully. Rats that are already chewing on the corners may chew a rubber seal too, so add metal protection at the corners where you see tooth marks.

Can mice climb up the garage door tracks?

Mice are good climbers and can move along rough surfaces and framing in a garage. The bigger risk is gaps at the bottom and sides, so close those first.

My garage door seal looks fine but I still see droppings. Why?

Rodents may be coming in another way, such as through the attic above the garage, a gap where the wall meets the slab, or an open side door. Look for droppings trails and rub marks to find the route.

Need the garage sealed?

Call for a rodent inspection of the garage and the rest of the house.

Similar Posts