Roofline entry points

Roof Returns and Eave Gaps: The Rat Entry Most Homeowners Miss

Stand back from your house and look where a lower roof meets a taller wall, or where the gutter line ends against the side of the house. That joint, called a roof return, often hides a gap straight into the attic.

Serving Mesquite 75149, 75150, 75180, 75181 and 75182

Roofline gaps

  • LookWhere roof meets wall
  • Also checkFascia ends, soffit corners
  • ClueDark rub marks
  • Rats needAbout ½ inch
  • FixSheet metal or hardware cloth

What is a roof return and why do rats use it?

A roof return is where the end of a roof edge, usually with its fascia and soffit, turns into or meets a wall. Builders often leave a small open space behind the trim there. Roof rats climbing from branches, fences or wires can slip through into the soffit and from there into the attic. Sealing it with metal closes the route.

The CDC’s seal-up list puts the roof first: among the rafters, gables, eaves and soffits. Roof returns are a specific kind of eave gap that’s easy to overlook from the ground because the opening sits behind the trim.

How to spot one from the ground

  1. Walk around the house and note every spot where a roof edge ends against a wall: porch roofs, garage roofs, two-story transitions and bay windows.
  2. Use binoculars or a phone camera zoom to look behind the end of the fascia and under the soffit corner.
  3. Look for daylight, missing trim, chewed wood or a dark grease smear around the opening.
  4. Check for droppings on the ground or the lower roof directly below.
  5. At dusk, watch whether rats travel along a fence or branch toward that spot.

Stay off the roof unless you have the experience and safety gear. Use a spotter on ladders and never work near power lines.

Other roofline gaps worth checking

  • Gaps where fascia boards have pulled away from the roof decking.
  • Soffit vents with torn or missing screens.
  • Gable vents with damaged screening.
  • Holes around plumbing vent pipes that go through the roof.
  • Rotted wood at corners and under gutters.

How these gaps are sealed

UC IPM recommends sealing any opening larger than ¼ inch with materials rats can’t chew, such as sheet metal and galvanized hardware cloth or expanded metal for vents, and warns against lightweight chicken wire. A roof return is usually closed with a piece of sheet metal or hardware cloth shaped to the opening and fastened to the framing, sometimes with new trim over it. Rotted wood needs to be replaced first, or the patch won’t hold.

Before sealing, make sure rats aren’t still inside the attic, or they may chew their way out somewhere else. This is why sealing usually follows trapping. Our pages on rats in the attic and rodent exclusion explain the order.

Close the routes up, too

A sealed gap stays sealed, but limbs and vines touching the roof keep bringing rats to test it. See how rats climb walls and downspouts for the routes rats use to reach the roof.

More questions

Can mice get in through roof returns?

Yes. Mice can climb and fit through even smaller gaps, about ¼ inch, so the same openings work for them.

Is a roof return gap a roofing problem or a pest problem?

Both. It’s a construction gap that rodents use. Roofers can repair trim, and rodent exclusion work closes the opening with chew-resistant material.

Will a gutter guard stop rats?

Gutter guards keep leaves out but aren’t designed as rodent barriers. Rats can travel on or under them.

Want the roofline checked?

Call for an inspection with photos of every gap.

Similar Posts