Inside entry points
Sealing Pipe Gaps Under Sinks and Behind Appliances
Plumbers often cut holes bigger than the pipe. That leftover space around the pipe, hidden at the back of the sink cabinet or behind the washer, is one of the most common ways mice move into kitchens and bathrooms.
Pipe gap fixes
- Small gapsSteel or copper mesh + sealant
- Larger holesMetal plate or hardware cloth
- FinishTrim ring (escutcheon)
- AvoidFoam alone
- CheckKitchen, baths, laundry, water heater
How do I seal around pipes to keep mice out?
Pack small gaps around pipes tightly with steel wool or copper mesh and seal over it with caulk. For larger holes, cover them with sheet metal, a metal plate or hardware cloth fastened to the wall, then add a trim ring around the pipe. The CDC recommends steel wool for small holes and metal, cement or hardware cloth for larger ones.
The CDC’s list of indoor places to check starts with kitchen cabinets and the pipes under sinks and washing machines. These gaps connect to wall voids, so mice that get into the walls from outside can come out wherever a pipe hole is open.
Where to look
- Under the kitchen sink: supply lines, drain pipe and the dishwasher line.
- Under bathroom sinks and behind toilets.
- Behind the washing machine and at the dryer vent.
- Around the water heater, gas line and water softener.
- Behind the refrigerator where the ice maker line comes through.
- Where pipes go into the slab or through the floor.
Use a flashlight and look behind the pipe. Gaps often sit at the back where you can’t see them from the front. Droppings or gnaw marks nearby tell you the gap is in use.
Step by step
- Make sure mice aren’t living in the cabinet or wall right now. If you’re catching them, keep trapping until the catches stop.
- Clean the area first using the CDC’s wet method, not by vacuuming.
- For gaps up to about an inch, pack steel wool or copper mesh tightly into the gap with a screwdriver. Copper and stainless mesh don’t rust like plain steel wool.
- Seal over the mesh with caulk to hold it in place and close air gaps.
- For bigger holes, cut a piece of sheet metal or hardware cloth larger than the hole, cut a slot for the pipe, and screw it to the cabinet back or wall. Seal the edges.
- Slide a trim ring (escutcheon) over the pipe to finish the look.
- Check the spot after a week for new chewing or droppings.
Materials that don’t hold up
UC IPM’s house mouse guidance lists rubber, vinyl, plastic screening, expanding foam and wood as materials mice can chew through. Foam alone is a common fix that fails. Use it only to hold metal mesh in place, if at all.
Gaps outside the cabinet
A pipe hole under the sink is often the last step of a longer route. Mice may enter from the garage, the attic, or a gap where plumbing or AC lines come through the outside wall. If you seal the sink and they show up behind the stove, look for the outside entry. See how small a gap mice can use and mouse control in Mesquite.
More questions
Can I use spray foam around pipes for mice?
Not on its own. Mice can chew through foam. Pack the gap with metal mesh and use sealant over it.
Will steel wool rust under the sink?
It can, especially near leaks. Copper or stainless steel mesh resists rust better.
Do I need a plumber to seal pipe gaps?
Usually not for small gaps around stationary pipes. Don’t block shutoff valves, cleanouts or anything that needs access.
Mice keep coming back under the sink?
Call to find where they’re entering the walls.
